EMERALD PAINT PUTTY INT & EXTERIOR

Xem chi tiết >

EMERALD PAINT PUTTY INT & EXTERIOR plaster is a smooth, fine plaster powder that is specially formulated to smooth, smooth surfaces prior to application.

Description

DescribeEMERALD PAINT PUTTY INT & EXTERIOR plaster is a smooth, fine plaster powder that is specially formulated to smooth, smooth surfaces prior to application.
ApplicationSuitable for repairing defects and creating a smooth surface on concrete, mortar, brick. . before painting. Use for indoor and outdoor
Specifications 
IngredientCement: 20 – 24%
 Mineral powders: 73.5 – 78.5%
 Additives: 1.5 – 2.5%
ColorWhite
Proportion1.20kg / liter (dry powder)
Theoretical coverage1.2 – 1.3Kg / m2 / 2 layers (depending on machining surface)
Thickness1 – 2 mm / layer
Drying timeDry surface: 2 hours
 Dry: 1 day
Packing40 kg / bag
Construction Guide 
Surface preparationSurface must be dry (moisture should be less than 16% by Protimeter moisture meter or dry wall surface from 21 to 28 days under normal conditions (average temperature is 300C, humidity is 80%). No dirt, grease, wax or other impurities
ToolPlate or fly stee
How to mix and mixPutty: Clean water = 2.4 – 2.6 kg: 1kg

Put enough water into the container. Apply from the dough

Apply and mix well until the mixture is smooth and homogeneous. If the mixture is too long before application, do not add water to dilute.

Execution1. Graduated layer 1 with a thickness of 1-2 mm on the prepared surface

2. Layer 2 has the same thickness after the first coat is dry for 1.5-2 hours.

3. After plastering layer 2 for about 1-2 days, proceed to sanding to smooth the surface with suitable sandpaper.

After rinsing, use a light brush to coat the outer layer of the coat and then use wet rags or rollers to absorb water then wait about half a day for the dry wall back.

Note during constructionDo not apply to surfaces with temperatures exceeding 400C. If the surface is dry and high absorbency, it should be moistened with clean water and reduce the surface temperature before application. When the powder, it is necessary to observe the powder surface after application, if there is air bubble emerged. Tightly squeeze back and forth when the powder is still wet to remove bubbles on the surface.

Do not spread on painted surfaces or surfaces that have been glazed.

PreservationStore in a cool, dry place, away from direct sunlight, place on a shelf at least 10cm away from the floor.
Storage time12 months in full condition
Safety and environmentKeep out of reach of CHILDREN. Wear gloves, masks and eye glasses when handling the product and when applied, if it is sticky in the eyes should be washed with clean water and immediately to the doctor. Do not throw the powder into the environment, do not pour the powder down the sewer and water. Carry carefully.
Exclusion clauseThe information provided is based on laboratory results and actual experience. However, under different conditions may be a deviation